Thrustor / Thruster Brakes

1
Thrustor Brakes Thrustor Brakes The ‘Suni ’ thrustor/ Thruster is electro hydraulic device to apply pressure or actuate lever
mechanism of brake arrangement.
An Electro-hydraulic thrustor,Thruster is an independent mechanism which requires neither clutches nor external piping. The thrustor,Thruster cylinder accommodates a centrifugal pump and a piston with two push-rods extending outside through thrustor/Thruster cover and transmitting effort to the brake
The robust design "Suni" Make Thrustor/Thruster unit is compact and has long life and is easy to maintain.
Main components used are of high quality cast iron and steel.The"Suni" Make Thrustor/Thruster is operated by an integral three phase squirrel cage motor. The device has the following advantages:
1. Constant Pressure
2. Gentle Application and release of Brake without
jerks and shocks.
3. Larger number of switching-in operations per hour (up
to 720).
The rated stroke of each type of thrustor/Thruster can be changed, retaining the same attractive force, by means of sleeves fitted on the rods (inside the body) (this arrangement is possible with models from Suni/ ST 535 and above) In cranes / hoisting machinery, brakes are intended for controlling the speed of load, lowering or for holding the suspended load at rest
"Suni" Make Mill duty Thrustor/Thruster Brakes are suitable for 400/440 Volts, 3 Phase A.C.50 C/S supply for a wide range of drum sizes, from 100mm to 600 mm dia. Higher sizes can also be supplied against specific requirements.
The brake is applied by the tension of the compressed springs mounted vertically between the thrustor /Thruster and brake lever. The thrustor/Thruster rods are connected with the brake by means of an angle lever. As the piston travels upwards the angle lever turns, pushes the brake rod and compresses the brake spring. Simultaneously, the brake lever on the other side of the wheel (Brake Drum) is retracted. The brake lever at the thrustor/Thruster begins to move when the first lever reaches the stop on the brake base member
The thrustor/Thruster and the brake are so adjusted as to reserve about 1/3 of the stroke for compensation of the wear of the brake linings.

Suni/MDT20018
Suni/MDT20018

Thrustor dia 100 /150
Thrustor dia 100 /150

Check All / Uncheck All